Ma in realtà le Jura non sono il massimo. Per quelli che hanno speso un capitale per farsi la casa domotica, c'e' un modello di nota marca tedesca pilotabile da bus che usa cialde di vari gusti, e quindi puoi programmare il sistema domotico per realizzare il caffe' del gusto che vuoi premendo un pulsante in camera, ad esempio. E' una macchina che ha pure un discreto successo, nel suo genere. E costa il doppio della Jura.
Se si assaporare ogni goccia di una tazza al mattino, poi si desidera una macchina che può erogare il rispetto degli standard. Anche se ci sono alcune marche di caffè High-end diversi là fuori, nessuno di loro si avvicina Jura. Questa azienda rende alcune delle migliori macchine sul mercato. Sì, sono un po' caro, ma il fatto è che è come avere il tuo barista personale nella vostra cucina.
The users are raving about it and if you’re the type who needs to have the cream of the crop, then there’s no better espresso machine out there than the DeLonghi PrimaDonna ECAM28465 . With this bad boy, you’ll never have to worry about loss of quality when preparing your favorite coffee drinks, since the PrimaDonna uses high quality internals and sophisticated coffee preparation modes to ensure that you’re going to get a delicious cup of your favorite coffee drink every single time with just the push of a button.
There were two machines on a shelf. Same brand, same shape and (judging by the description) same capcity, one of them was completely cromed the other one had a golden line, the one with the golden line was a cool 100 euros MORE than the other. So, what's the difference between them? After some time spent reading the specs of the two machines the guy had to admit that the golden line was the only difference between them.
Six years and 7540 shots of espresso. The only downside of this machine is that it is too easy to use so that you end up drinking more cups than you might otherwise. It's very fast to heat up, both for the main heating block, as well as for steam. The steamer wand takes some practice to get good, tight foam, but once you figure out the technique it's not difficult. The openings in the wand can clog up if you don't wipe it down right after use. I also give a short blast of steam right after that as well. After about five years we bundled it up and sent it in to the factory for cleaning and reconditioning. It came back as good as new and it's still going strong. About the only real negative aspect to the machine is that it tends to be a bit noisy, but probably no more so than someone using a fully manual pull machine and grinder.